|
5 Easy Steps
The QuickEvac™ system allows your technician to perform a complete engine oil and filter change in less than 20 minutes, no matter what sized machine you own. The five easy steps are all safely done from a single service point. |
|
|
| |
|
1. Purge oil filters
Disconnect the line-to-oil filter at the QuickEvac™ system bracket, connect a compressed air line, and apply air through the filter. After about 10 seconds, remove the air line from the line-to-oil filter – filters are empty and ready for removal without spills. |
|
 |
|
2. Evacuate the sump
Connect the hose assembly service tools from the PM truck’s waster line or the manual service tool to the QuickEvac™ system pump’s quick disconnect fitting. Switch on the pump and evacuate the engine, which is typically completed in less than 60 seconds. |
|
 |
|
3. Change the filter
Remove the used oil filter and replace with new filter. Do not pre-fill with fresh oil. The QuickEvac™ system automatically fills the filter and engine oil correctly, fully filtering the new oil and pressurizing the engine as part of the refill. |
|
 |
|
4. Fill new filter and engine with new filtered oil
Connect your clean oil fill to the line-to-oil filter. Fill with clean oil. Verify the oil level in the sump with the dipstick, without starting the engine, and adjust, if needed. |
|
 |
|
5. Reconnect the QuickEvac™ line
Reconnect the line-to-oil filter at the QuickEvac™ bracket. Your engine will be automatically prelubricated and ready to start. |
|
 |
